AgTalk Home
AgTalk Home
Search Forums | Classifieds (37) | Skins | Language
You are logged in as a guest. ( logon | register )

Lightweight/economical ISO Display
View previous thread :: View next thread
   Forums List -> Precision TalkMessage format
 
c_mayer
Posted 12/26/2024 07:21 (#11026371 - in reply to #11024681)
Subject: RE: Lightweight/economical ISO Display


Jeffersonville, OH
neo_ag - 12/24/2024 21:32

Buying a used guidance display is probably more than you are looking to spend, but it does appear from this diagram a Trimble GFX is an option. If you are interested, I have a battery to hitch harness with CAN wires, relays and a Powell ISOBUS plug that might also work with your setup if the tractor doesn’t have a plug. Guidance display would also have camera capabilities. If you want photos of the display, harness and possibly a power bus, let me know and I will post them as a reply.

If someone else knows this isn’t possible without a NAV receiver, please let me know.

https://talk.newagtalk.com/classifieds/Classified.aspx?id=249253




No, that should work fine, as should your other posts "rigged" ISO Harness....I don't see that as rigged at all. ISO is not Voodoo, it's 2 wires to talk CAN language....I have done way worse to get ISO to a certain monitor or another in a cab. This is assuming you have a good "high current" power source for your ISO connector on the rear of the tractor.

This spring I was trying to diagnose a steering issue in a AGCO tractor that's ISO steering, but the display in it wasn't a new enough standard to run the steering control, so I pinned a jumper harness to run a Topcon AGI4 into an Ag Leader InCommand 1200 in about 3 minutes, and was steering a Topcon system through an Ag Leader display...was actually a nicer way than trying to run it on a non touch screen AGCO display of that time LOL

That is one thing I really like so far since becoming a Trimble dealer too, their harnessing is MUCH more thought out than Ag Leaders one size fits all approach. Drives me nuts to bundle up 30' of harness in a cab trying to make an install look decent

Chris

Edited by c_mayer 12/26/2024 07:22
Top of the page Bottom of the page


Jump to forum :
Search this forum
Printer friendly version
E-mail a link to this thread

(Delete cookies)