|
| Bought a planter that came off a green tractor, but controlled by a 20/20. This is going to be pulled by an older non isobus case. Planter Has separate foldbox and all that works fine. But it has a isobus connector which I couldn’t figure out why. My assumption is and now even stronger after I hooked up all the 20/20 cabling today and tried to test everything and it didn’t recognize the rowflow’s, they are powering the row flow modules through the iso harness big power pins, which I can’t hook up. Currently don’t have any other isobus implements. I’m steering this tractor with an agleader 1200. What is the cleanest and most cost effective way to make this all jive? | |
|
Precision row flow/ isobus
