|
SEQ, Australia | From the Rate Control Module, you need 75526 & 80540, which are the generic harnesses. 75526 goes from the module to the Power/CAN wiring breakaway on the rear of the tractor, and there are a few options to get it there, but usually a 77611-01 ISO style Implement connector and the a 75528-XX (length in 10's of ft). The Seed monitoring module will usually daisy-chain off this 75526 as well, and then a 75529 Terminator on the end of the chain.
There is a Sensor Adapter kit to pick up the sensors (RPM/Pressure/PWM Drive/Bin Level/App Rate) on CNH planters (80510-61) but you would have to confirm what sensors your machine has.
The Seed Monitoring Kits are usually for the Dickey-John (PM) or Deere CompuTrac (CT) style console replacement, and I know you can't adapt it to the "smart" sensors on the late model Early Riser planters
If you are currently able to run your shutoff's through the EZ-Boom, you will be easily able to adapt it the 12Pin DT on the end of the 80540 harness
Edited by Trimbleguy 3/9/2025 21:23
| |
|
Caseih fmx 750 for section control and planter monitor
