|
Wood Lake, MN | Where would I find this 209 wire, I have a JD 8230 with the 2600 display, I have a short cable that goes from the 2600 to the cornerpost of the tractor.
On my Raven I was already useing a relay switch to turn mapping on and off in my ipaq. I also have a whisker switch mounted on my planter when I was useing the ipaq. My relay for the raven and my whisker switch for the planter already have DB9 ends on them, if I put the third party harness from deere on the harness behind the 2600 Part # PF90363 could I hook the db9 together and get signal into the 2600 that way?
Just a side note I don't use the planter whisker switch and the raven at the same time.
Now for the next question, If I can use the DB9 end and I already have this PF90363 cable on my 2600, I have it hooked up to my CIH Pro 600 monitor and use it to bring gps into the Pro600. On my relay and whisker switch they both have DB9 T ends on them, when I was useing them on ipaq I had gps hooked on one end and the other end went tot he ipaq, Can I hook the T in between my Pro 600 and 2600 when planting or should I install another PF90363 to keep it seperate and use it on com 2?
Edited by jasonswmn 3/10/2008 07:23
| |
|