Hagen Brothers farms,Goodrich ND | Depends on what you need. My 1482 pultype conbine was a pain to unload when being pulled with a Steiger 4wd with wide spaced duals. You could not run close enough to the truck with the wide tractor to get the unload auger over the center of the truck,usually had to drive past the truck and back the combine up to the truck,a real PITA. I found the optional unload spout for a 1480 with the 30 ft header fit on the 1482 and got the grain about 3 ft farther out from the end of the auger by replacing that hood with a spout. Could then run the outside dual a ft from the truck and still unload in the center of the truck.
Edited by Jon Hagen 9/19/2006 00:25
 (Steiger + combine rear jpg.JPG)
Attachments
----------------
 Steiger + combine rear jpg.JPG (17KB - 123 downloads)
|
You ever notice on unloading augers??
