|
| I am driving a 9750 combine in beans. I've had trouble with the automatic header, it was creeping up on me, contour master not working right. When I would hit the lower button one side of the head would go down the other would stay up. and sometimes would not lower at all.
I recalibrated the head and it started following the ground better, but now it bounces and hops all the time. I either have to turn the knob all the way up or all the way down. Ive tried recalibration and it helped some i think but still does it. It will give out some codes during calibration about low voltage.
another question is about the tailings monitor. i have it set to where i have a good sample, 530 on the rotor, 1150 on the fan and 22 on the convace , not much going out the back, but the tailings show pretty high, what does that show and what can i do?
| |
|
Question about a 9750
