|
NC KS | With the CVT in the Agco tractors, you pull up to truck. Leave tractor in forward on the forward-reverse selector. Use the stick on the arm rest to bring speed to zero. Start unloading. If you need to move an inch you just nudge stick on armrest or nudge forward-reverse lever. Leave tractor running pto speed all the time. Smoothest tractor on a grain cart period. When done unloading, hold stick forward and you will be moving 20 mph in a matter of seconds if you need that kinda of speed. When chasing the combine, same thing, you can decelerate from 15 to 4 in a matter of seconds. It is the fastest tractor around to go from 0-road speed or vice versa. There are other ways of running it too. You can use pedal mode where the accelerator pedal controls engine and tranny just like driving an automatic in a vehicle. You set the engine rpm to tranny ratio. You can have an economy setting where the engine goes up a little in rpm and tranny goes much faster or power mode where engine rpm increases faster than tranny.
Kelly | |
|
Is anyone using a JD w/IVT on grain cart?
