|
| I want to count bales and plunger strokes per bale from a small square baler. Maybe keep a running average of the strokes/bale for the last 3 bales. If this works, I could see adding a humidity sensor also. I think proximity switches on the plunger and the needle arm will allow me to do this, but I need to do some logic to keep track of strokes per bale. Im not opposed to an Arduino if that would be best for this application. I have done quite a bit of programming many years ago in school, and am looking forward to trying to write a program that will do this. Any help or suggestions would be much appreciated. | |
|