|
| Is the needle prox a one-shot, or does it have a duration? If it has some type of duration, then you probably should be using a rising edge contact rather than a normally open contact. Otherwise it will load your averaging registers too quickly.
I am just learning how to do this in the CLICK programming language, and it works pretty slick. But no guarantees that I am doing it right...
Here is an averaging routine from the grain dryer program-
Edited by Up Nort 12/1/2019 15:34
(temp_average (full).JPG)
Attachments ---------------- temp_average (full).JPG (36KB - 113 downloads)
| |
|