| 1466driver - 6/9/2023 22:09 on the bottom of the single point hookup should be 5 lines , the 2 big steel lines are the reel drive lines . the 3 smaller steel lines are 2 for reel fore and aft and 1 is reel lift . shouldn't take much to figure out what is what there , just to eliminate that your combine isn't sending oil to 2 ports at the same time , The header plumbing is pretty simple , the only other thing i can think of happening is the hoses being hooked up wrong going to the fore /aft cylinders .
Or a bad male tip/female coupler in the single point.
Id probably try taking a hose off of the single point coupler. Have someone hold it in a bucket and see if oil comes out. If it does, then do the same with the other hose removed from the coupler.
It’s not a complicated system at all. It’s the same as any other platform header with a hyd lift reel that has been built in the last 50 years.
What combine is this on? Have you used it on this combine previously and it worked as intended?
Flagship combines have all sorts of things that need to be properly setup in the Pro 600 or Pro 700 screen. Including settings for hyd uses on the heads.
Edited by Kooiker 6/9/2023 22:44
|
2009 Caseih 2020 header hydraulic problems?
