|
northeast ohio | Is your dealer suggesting you get speed from the TM200 module or is it off of a connection plug on an attached NAV 2 or 3? I believe the 12 pin port A and the exp 100 expander are the same pinout (as was case with FMX port) see diagram below. If port A is open or cabling such as a 75741, 75407 or 75834 has a 12 pin expansion plug then it should follow the diagram as well.
If you need NMEA positioning, then searching the web using “NMEA Trimble TMX” yielded quite a few AgTalk threads on the subject. Some suggest difference between setups with NAV and EZPilot while others mention FMX+ vs PIQ. Issues like they discuss may have been addressed with firmware upgrades. However the Trimble cabling guide does indicate radar not available with EZPilot. https://mytrimbleprotected.com/knowledge/docushare/retrieve?handle=F...
This video is also available. https://youtu.be/DuSpgmgXwiU
Edited by neo_ag 2/7/2024 05:25
 (IMG_9743 (full).jpeg)
Attachments
----------------
 IMG_9743 (full).jpeg (107KB - 16 downloads)
| |
|
Gps/radar speed from TM-200
