|
Jeffersonville, OH | This. No way to do it other than through the roof connection for the Radio/Modem, it may be marked "Satel". Typically a 6 pin Deutsch connector.
Pin 1 is Switched Power
Pin 3 is Signal Ground
Pin 4 Tx/Rx
Pin 5 Tx/Rx
Pin 6 is Battery Ground
Then your external radio settings should be correct in the NT01 Terminal to make it work. So, you'll have to make up a cable from DB9 to Deutsch to make it work, but you also should be able to pull power from that to power your Bluetooth adapter. Personally, I would try and route it down to where you can get at it down by the rest of those connectors.
That should get you I believe. Never tried that adapter, but have used Intuicom Bridge x's with that CEA guidance system on 6 or so units and they work fine. Should be able to make that work once you get it wired right.
Chris
Edited by c_mayer 2/9/2024 07:27
| |
|
Rtk with ntrip app challenger/fendt tractor
