|
SE NE | Just switched our strip till from AgLeader to Deere Rate Controller 2000. On AgLeader for my NH3 flowmeter I had "72" for my cal number. What do I need for Deere?
Tag on Raven meter:
720 gal or 170 NH3 lbs of N
RC2000 only gives me the option to use units of 10 gal
Tried 720 and the control valve opens all the way and says it can only hit a rate of 70-75 lbs N
Tried 72 and it locks on rate but judging off the pressure gauges it seems low (ground is a little wet yet so didn't run long)
Should I be using the 170 number or could I have something else wrong?
Edited by mrahe 2/19/2024 09:46
| |
|
JD RC2000 NH3 Flowmeter Setup
