|
| I'll try setting everything on the ISO side and we will see where it goes. As I mentioned in a post above, Changing the material does not change the density or anything on the ISObus side, but changing the rate in PrecisionIQ changes it in the ISObus terminal. I can not change the swath width in PrecisionIQ. In order to do this I need to change the swath width in the ISObus terminal. It's like I have to do half of the settings on each screen!
My guess is setting the rate and then doing section control is all through precision IQ but the actual spreader settings like gate opening, swath width, density, and other similar things are all set on the ISObus side of things | |
|
ISO and Trimble
