|
Ohio | Hello, the In Cab IsoBus plug is used first of all to exclude additional cabling and one more IsoBus socket on the tractor.
However, answering to your question.
You can control your implement or from Intelliview or from TMX you need to setup UT/TC FnI number to be the same in your implement menu and in your monitor menu, and make sure that they are not the same in both monitors.
About other tractor function in TMX, do not think so, there are some IsoBus terminals that allow to monitor tractor data such as Engine RPM, hitch, and other data, but I don't think Tmx has this.
About GPS position, TMX has the function to send to IsoBus GPS data in J1939 or NMEA2000 format if i am not wrong. Here it depends if your other terminal or implement can read this data and use it.
Additional to this, Trimble new InCabIsoBus Cables allows you to power your monitor, without the need to route another cable from Battery to Your terminal. | |
|
Trimble ISObus in-cab connection
