|
| Hi, I am running Precision IQ on a Trimble XCN 2050 doing section control on an Amazone granular spreader. The operator timeout kicks in after fifteen minutes and stops the spreader due to no operator interaction with the screen. Then the task has to be stopped and restarted to get it to work again. The operator timeout is set to it’s maximum of 15 minutes and cannot be further increased. Tapping the screen at random extends to 15 mins again but it is difficult to always remember to do this.
I can understand why there is operator interaction required for autosteer safety but not section control. I have tried not enabling autosteer at startup to see if this makes any difference but it does not. The old FM1000 app did not do this but it will not run with the latest Amazone firmware.
Question is how do I stop the operator timeout stopping the section control or can it somehow be significantly increased? Thanks. | |
|
Trimble XCN 2050 operator timeout
