|
| Thanks to everyone who chipped in trying to solve the wiring dilemma. In case anyone runs into the same challenge my Solution was to add four wiring tsplice connectors before the 4pin deutch connector and then run wires from there to the CAN terminator on the other wiring harness.
I had two agexpress harnesses purchased new and one factory John Deere harness that came with the used Atu 300. Could have bought new CAN terminator for $40 and tried to track down a 4 pin deutch connector, but t-splice and wires was easier.
Spent several hours reading researching online the CAN bus system of how electric components communicate with each other. Now, almost feel like I could build a self driving car after learning about CAN backbone :) | |
|
Atu 300 in Deere 8100 tractor _ help?
