|
NE Indiana | I converted our 1790 from seedstar 1 gen 2 to seedstar 2. Planter is just ground drive no clutches. When I raise up on the ends the monitor goes nuts. There is a box to check that says something like ignore seed sensors on headlands. When I check that box it says height sensor not calibrated. When I go into the sensors screen to calibrate it, height isn't listed as a sensor in there. When I go to the diag screen and look at voltages it shows a height sensor there, but it just reads 5.17 volts all the time. I have a button switch on one of the row units from when we ran the planter with agleader. Does anyone know where the height sensor wires in to the wedge boxes? | |
|