|
| Okay so I figured out the flashing stop with no alarm codes present. There is a toggle switch (looks factory) wired into a jumper on the harness that is for operating the twine arms. I have to unplug the toggle switch and plug the other set of wires in the stop alarm goes away but I cannot operate the twine arms using the monitor buttons. Weird.
I also cannot access or adjust the bale diameter on this monitor. A few things of note are that these buttons worked at one time as they are all worn to the point you can’t see what they are and this monitor was used on an open station tractor this entire life.
I have a friends 566 baler and monitor so I plugged it into my baler and even with the toggle switch wired in I was able to operate the twine arms off of the monitor.
I’m thinking I need to send this monitor off for repair and I’m curious who should I send it to? This baler has net wrap capability but it has never ever had a roll of net wrap in it. I’d like to move toward using wrap.
Thanks
Caleb | |
|
|
567 Baler monitor help
