|
Southwest Minnesota | I want to move my autosteer from my 440 to my mx215 which is autosteer ready from the factory.
Equipment I have----
-Trimble Nav 2 controller
-Agleader Insight
-252 receiver
Does anyone know how this is accomplished. I tried a bit today, but things don't seem to be working.
I get a yellow flashing light on the back of the 252(can't remember what that means).
I'm not sure how the 252 is getting power, because in the cab there isn't any switch to turn it on.
I have not put a tractor configuration in the insight yet, I was just trying to get the 252 to have signal.
Is there any special cables that I need or should I already have everything.
Thanks.
| |
|
Moving Trimble Autosteer from stx440 to mx215????
