|
SE PA | Yup, there's 2 valvle slices for the loader, and they are both different from each other, and different from the 'normal' ones. Joystick cables run to those, through the grommet in the floor. There are 3 threaded rod that hold the valve stack together - you need those. Hoses run front from the valves to the coupler - One one of ours the hoses come straight out, and on the other they have an L, and go downward - I think that's better. You need the entire joystick and cables (hole is already pre-punched in the console), and the hoses/fittings/couplers/bracket for the mid-mount disconnect. I would suspect that if you have a joint in your hoses, you just need some fittings to accomplish most of the connecting...... The hard part is already done - the loader is on......
Rodney | |
|