Well for your machine you'll need the feederhouse hooks and the new facia I listed above, a $200 or so dollar display conversion, as well as one of the kits I've listed below. Also, if your combine is an older 9650, you may need to do a controller update. Like I said before, our dealer has STOPPED selling the wedge kits.

Our 9650 was a 2002 model. We wound up with the single point conversion which cost $1500 at the time, the $500 hooks and facia, and the $200 display update. That totaled $2200. My uncle had an extra $500 in his because it was an early model 9650 and it needed a new controller "chip". We did all of the conversions and everything but the "chip" ourselves. It is very clearly laid out in the instruction manual. Took me about 6 hours to put the single point hookup on myself on our STS.

If you have a walker you'll need one of these kits: 

Multi-Connection (Hydraulic/Electrical) Point Conversion to
Single-Point (Hydraulic/Electrical) Coupler for 50 Series Walker
Combine Up to PIN 695101 and Up (with Hydraulic Hose Lines)

BH84208

$999.00

                             

Multi-Connection (Hydraulic/Electrical) Point Conversion to
Single-Point (Hydraulic/Electrical) Coupler for 50 Series Walker
Combine Up to PIN 694000 (with Steel Hydraulic Lines)

BH84209

$1,001.00

 

Multi-Connection (Hydraulic/Electrical) Point Conversion to Single-
Point (Hydraulic/Electrical) Coupler for 50 Series STS Combine
only. Converts 9650STS and 9750STS to a Single-Point
(Hydraulic/Electrical) Coupler

BH84207

$999.00