|
West Central IA | Have an 8220 with a Trimble valve on it. Been running legacy steer command but am trying to put a z2 on it. Got a Trimble harness but I’m not sure it’s going to work. Looks like there are adapters for the DIN connectors available but not included but the enable solenoids have permanently attached wires that go to a 6 pin connector which y’s to kick out.
If the enables are the only issue could I just splice the wires? Polarity isn’t an issue if I get l/r correct?
The pressure transducer/kick out adapter fits.
Edited by fox128 2/23/2024 18:26
 (IMG_5299 (full).jpeg)
 (IMG_5300 (full).jpeg)
 (IMG_5301 (full).jpeg)
 (IMG_5303 (full).jpeg)
Attachments
----------------
 IMG_5299 (full).jpeg (142KB - 78 downloads)
IMG_5300 (full).jpeg (132KB - 80 downloads)
IMG_5301 (full).jpeg (179KB - 77 downloads)
IMG_5303 (full).jpeg (147KB - 78 downloads)
| |
|
Steer Command Z2 with older Trimble valve?
