|
Ohio | Hello, i do not have a lot of experience with AGRA Bridge, but i can tell you for sure it will not work untill you disconect NAV2 from tractor CAN Bus.
Because the Can Bus and ISO Can BUs power is conected in series with NAV2.
So you are connecting AGRA Bridge to TOP Dock to the same BUS as NAV2 is connected, this will not work.
Atached is an file with the NAV2 connection to CAN Bus location.
Regarding to your question it is a factory agco hyd valve and trimble systems just installed instead of using the monitor.
The comunication is going through ISOBUS Can BUS. So Trimble NAV2 is sending commands to the valve, but its not just a simple valve, it has it CAN controller- well its a big story how this works.
**If no response is received in 24 hours, the answer will be deleted as not useful answer
Attachments
----------------
 can location.pdf (163KB - 14 downloads)
CANBUS location.pdf (426KB - 9 downloads)
| |
|
Challenger 945c autosteer questions.
