|
sw corner Ia | My drill has early riser units, first of all. They already use the cyclo diffuser that drops into the seed boot in the unit. I used cyclo seed delivery plastic tubes that fit directly into those for the lowers. I then went to menards and found some heavy walled 2" pvc and used that for the uppers. I used my die grinder to flare the upper openings of both so seed would continue without bouncing. Also used same die grinder to make a lip on the outside of the upper pvc so I could clamp a short piece of the radiator hose with a plastic tie. If you have double disc units, this would all be different.. If you can use this setup, the cost is very low. I have had no problems with these in the last four years of use. | |
|
Case IH 5400 drill
