|
SE ND | I'm trying to get an Ag Leader strip till module to run a 3rd party hydraulic drive system on a John Deere 1910 air cart. I'm looking for setup advice and starting settings. First off, I don't seem to be recognizing the equipment switch. Do I need to have a switch box connected to the auxillary input module first, or do I just need to map it somewhere? Next, Deere meters have 60 teeth on the sensor ring. Does that equal 60 pulses per revolution for AL's shaft speed calibration? What are good starting numbers for PWM freq, PWM gain, and zero flow offset? Not sure I have manufacturer numbers for frequency.
TIA! | |
|