|
NW Iowa | The flag test should be within a few inches.Then go and fine tune with the start / stop seed measurement after digging seed. I would recheck all your measurements. I never asked if it was a mfwd, two track, or articulating tractor. Those measurements get complicated too if not an mfwd. Another one that can throw stuff off is the pivot point on your planter if it is a 2 point planter vs drawbar. The two point measurement is the pivoting pin on the planter-side. Not where the three point hitch hooks are on the tractor. Be sure your measurements on the Trimble display are correct also. | |
|
Gen 3 monitor not mapping cover accurately
