Jeffersonville, OH | Variorabbit - 4/3/2024 17:20
From top to bottom it goes et, edt, iso.
Yes, I could see needing iso data at some point.
Then you may need to get with Deere and figure out if it can communicate with more than one CAN network at a time, and tie into both. I can probably tell you which pins in each connector to get the information you want if it is capable. AGCO's Telemetry module can communicate on 4 I believe, but no idea what is possible with Deere on a retrofit installation.
Chris |
John Deere MTG in Challenger 765d
