Near Intersection of I-35 & I-90 Southern Mn. | Here's a picture of the homemade air control I purchased from a fellow AgTalker. Air comes in from the compressor and goes through a regulator (knob) that has a pressure gauge connected to it. That gauge shows the pressure in the air tank. The output from the regulator goes to the manual toggle type valve sticking out the top of the box. This allows the operator to raise/lower the units. The other gauge shows the pressure involved for the output.
Note one piece of tubing brings air pressure in (bottom tubing) and two routes for air to go out to raise or lower (upper tubing).
Edited by tedbear 4/16/2024 11:37
 (Air Control (full).JPG)
Attachments
----------------
 Air Control (full).JPG (100KB - 5 downloads)
|
Clean Sweep run with 20/20 AirForce compressor?
