NW MN | MF3680 - 3/21/2024 18:44
After doing some more research it looks like I need to connect A &B to activate the mapping. I tried doing that with a jumper but could not get the green logging button to turn on and off. Do I need a speed input to make the mapping work?
This is not my recommendation, but you can also activate the implement switch on an InCommand by starting a Guidance event and following the steps below. Legacy monitors may be the same, I just don’t have one around right now to confirm. Unless you are on a Compass or Guidance Only 800, there is no reason to do it this way vs an Application configuration and event.
Start a Guidance event and do the following:
 (IMG_0924 (full).jpeg)
 (IMG_0925 (full).jpeg)
 (IMG_0926 (full).jpeg)
Attachments
----------------
 IMG_0924 (full).jpeg (55KB - 24 downloads)
IMG_0925 (full).jpeg (51KB - 17 downloads)
IMG_0926 (full).jpeg (55KB - 17 downloads)
|
Agleader application rate module
