|
Southeast Illinois | I have a liquid setup with 4 shutoffs, a 12V magnetic flowmeter, a pressure sensor, and PWM controls for a hydraulic pump. The harness for those items terminates in a 37 pin connector with 12 pins being used (I believe it's for connecting to a John Deere rate controller). However, I want to use an Ag Leader liquid module to control everything and the harness for that terminates in a 16 pin Raven connector with an additional 14 pin connector that only has 3 pins being used (I think it's for a pressure sensor).
I cannot find any adapter harnesses to attach the two, so I will just splice them together. From what I've gathered from various posts here, I believe I have the correct pinouts and have matched them up, and would like some additional input from anyone to verify it is correct.
37 pin --> 16 pin
1 valve ground --> 1
4 driver 1 / section 1 --> 6
5 driver 2 / section 2 --> 2
6 driver 3 / section 3 --> 5
7 driver 4 / section 4 --> 7
15 servo - / PWM --> 4
16 servo + / PWM --> 3
21 flowmeter ground --> 11
26 flowmeter 12V --> 16
28 flowmeter signal --> 13
31 pressure signal --> red wire on 14 pin connector
36 valve power --> 16
Edited by tberger06 3/26/2024 08:04
(PXL_20240323_205006028 (full).jpg)
(PXL_20240323_195646290 (full).jpg)
Attachments ---------------- PXL_20240323_205006028 (full).jpg (151KB - 15 downloads) PXL_20240323_195646290 (full).jpg (160KB - 16 downloads)
| |
|