Posted 3/17/2024 11:03 (#10668445 - in reply to #10668216) Subject: RE: sprayer rate control with some boom valves off, section control
First a dumb question: Is the Auto / Manual switch of the Micro-Track turned to Auto.
Then question about wiring:
On the relay board black is common = +12V ?
Red is hot when section is off. But as they are connected together it is hot if any of the sections is off.
The black one +12V goes to the middle pole of the 7101 section switch but on the PCB it is the red one that goes to the middle connector of SW5. Is that right?
Can you please also take a picture of the other side of the PCB.
In this setup the Arduino Nano is connected with a USB-cable to your PC running the AgOenGPS software.
sprayer rate control with some boom valves off, section control
