Posted 3/29/2024 10:48 (#10685307 - in reply to #10683945) Subject: RE: Update
Thanks for passing along what you learned. This past week I had a little free time, so I pulled out a project I had been working on this winter. I ordered some rare control version 12 boards from JLC pcb this winter. I tried to build the AgopenGps rate and section controller. I ran in to road blocks and couldn’t make it work, so I shelved the project. This week I got it working. It turns out the two nano Ethernet shields I tried were bad. I ordered another brand and have it communicating with AgopenGps and the rate control app now. I hooked up an electric motor, a relay board and a cheap flow meter off Amazon to try it out. It works as it should. If I blow into the flow meter the motor speeds up and slows down. I couldn’t get a micro trak speed sensor to read on it last night, but I haven’t really looked into it yet. I may still section control the MT 3000, but at the moment things are looking good for the AgopenGps rate controller.
Here’s a link to the rate controller for anyone not familiar.
sprayer rate control with some boom valves off, section control
